 |
|||
|
|
|||
|
Page Title:
INSTALLATION OF FLYWHEEL, CLUTCH ASSEMBLY, AND TRANSMISSION ADAPTER |
|
||
| ||||||||||
|
|
 N o t e . It is not necessary to remove
Caution: When gasket cement is used
the timing gear cover assembly (fig.
during installation of oil pan, apply
cement only between the gasket and the
cap with attached oil pump idler gear.
oil pan. Never apply cement to the
cylinder and crankcase gasket surface.
(4) Remove oil pump drive gear following
d . Install Oil Pan. Refer to figure 277 and
instructions for figures 359 and 360.
reverse the sequence of illustrations and in-
structions to install the oil pan.
(5) Remove oil pump idler gear from front
Note. The three cap screws along the right
main bearing cap following instructions
for figures 301 and 302.
side the oil pan, near the front, are not in-
stalled until the flame heater fuel pump mount-
ing bracket is installed (par. 277).
the sequence of illustrations and in-
structions to install the new oil pump
idler gear.
reverse the sequence of illustrations
and instructions to install the new oil
pump drive gear.
verse the sequence of illustrations and
instructions to install front main bear-
ing cap with attached oil pump idler
gear. Tighten main bearing cap screws
to a torque of 1100 pound inches.
verse the sequence of illustrations and
instructions to install the oil pump as-
sembly. Check oil pump drive gear and
idler gear backlash as instructed on
c. Install Oil Pump Tubes.
(1) Oil pump outlet tube. Refer to figure
structions to install the, oil pump outlet
USING DIAL INDICATOR.
tube using new gaskets.
(2) Scavenger pump inlet tube. Refer to
ASSEMBLY, AND TRANSMISSION A-
DAPTER
of instructions to install the scavenger
pump inlet tube using new scavenger
a. Install Flywheel.
inlet tube gasket.
(1) Refer to figure 276 and reverse the se-
(3) Pressure oil pump pickup tube. Refer to
quence of instructions to install the fly-
wheel. Use the pilot bolt (fig. 160) to
instructions to install the pressure oil
position flywheel. Tighten flywheel
pickup tube. Install new oil pump pickup
mounting place bolts to torque of 650
tube gasket.
to 700 pound inches.
307
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals