 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 (3) Figure 276. (A) Remove top 1/2 x 1-1/8
place bolt and install pilot bolt to guide
a . General. The oil pan encloses the lower
flywheel during removal. (B) Remove
portion of the engine, houses the oil pump and
the remaining five 1/2 x 1-1/8 place
components, and provides for storage of the
bolts securing flywheel to crankshaft.
lubricating oil.
(C) Remove flywheel.
Note. Rotate cradle - 7950198 in engine over-
haul stand - 7950189 to bring oil pan area up to
the side for ease of removal.
b. Removal. Refer to figure 277 and remove
the oil pan and oil pan gaskets.
PICKUP TUBE, SCAVENGER PUMP IN-
LET TUBE, AND OIL PUMP OUTLET
TUBE
a . General. T h e pressure oil pump and
scavenger pump pickup and inlet tubes carry
oil to the oil pump. The oil pump outlet tube
delivers oil from the pump to the oil galleries
in the cylinder and crankcase assembly and to
all points pressure lubricated within the engine.
b. Removal. Remove pressure oil pump pick-
up tube, scavenger pump inlet tube, and oil
pump outlet tube as follows.
(1) Figure 278. (A) Remove two 1/4 x 7/8
cap screws and 1/4-inch lock washers
securing pressure oil pump pickup tube
to pump inlet. (B) Remove one 1/4 x 3
cap screw and 1/4-inch lock washer
securing pickup tube to pump cover.
FLYWHEEL.
(C) Remove pressure oil pump pickup
tube. (D) Remove and discard pressure
oil pump pickup tube gasket.
ENGINE OIL PAN.
PRESSURE OIL PUMP PICKUP TUBE.
171
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals