 |
|||
|
|
|||
|
Page Title:
REMOVAL OF TRANSMISSION ADAPTER, CLUTCH ASSEMBLY, AND FLYWHEEL |
|
||
| ||||||||||
|
|
 eight 3/8 x 15/16 cap screws and 3/8-
134. REMOVAL OF TRANSMISSION ADAPTER,
inch lock washers securing clutch cover
CLUTCH ASSEMBLY, AND FLYWHEEL
assembly to flywheel. Remove clutch
cover and driven member assemblies
a. General. The clutch assembly mounts on
as shown in figure 275.
the flywheel. Facilities for mounting the trans-
mission are provided by the transmission a-
N o t e . Fabricate a pilot bolt from a
dapter.
1/2-20 x 3-1/2 bolt by cutting off hex-
agon head and grinding sharp edges
b . Removal. Remove transmission adapter,
from shoulder. Refer to figure 160 for
clutch assembly, and flywheel as follows.
pilot bolt details.
(1) Figure 273. (A) Remove thirteen 3/8-
inch plain nuts and 3/8-inch lock
washers securing transmission adapter
to flywheel housing. (B) Remove trans-
mission adapter.
COVER ASSEMBLY.
TRANSMISSION ADAPTER.
(2) Figure 274. (A) Remove and discard
transmission adapter gasket. (B) De-
press clutch release levers, one at a
time, and place a clutch release lever
spacer block (fig. 25) between lever
and clutch cover as shown. The spacer
blocks relieve clutch cover spring ten-
sion against cap screws securing clutch
cover assembly to flywheel. (C) Remove
AND DRIVEN MEMBER ASSEMBLY.
170
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals