 |
|||
|
|
|||
|
Page Title:
TRANSMISSION ADAPTER AND FLYWHEEL |
|
||
| ||||||||||
|
|
 86. TRANSMISSION ADAPTER AND FLY-
WHEEL
a. Removal. Remove transmission adapter
and-flywheel as follows.
(1) Remove clutch cover assembly and
driven member assembly following the
instructions for figures 88 and 89.
Note. To replace transmission adapter
only, do not remove the clutch cover
and driven member assemblies.
(2) Figure 158. (A) Remove thirteen 3/8-
inch plain nuts and 3/8- inch lock
washers securing transmission adapter
to flywheel housing. (B) Remove trans-
FLYWHEEL.
mission adapter. (C) Remove and dis-
card transmission adapter gasket.
b. Installation.
Note. One flywheel cap screw hole in fly-
wheel and threaded hole in the end of crank-
shaft assembly is off location so that flywheel
can be installed in only one position.
(1) Fabricate a pilot from a 1/2-20 x 3- 1/3
bolt. Cut off bolt head and grind any
burs from shank. Install pilot in top
threaded hole in end of crankshaft as-
sembly as shown in figure 160.
TRANSMISSION ADAPTER.
(3) Figure 159. (A) Remove six 1/2 x 1-1/8
SHAFT WITH FABRICATED PILOT
cap screws securing flywheel to end of
crankshaft. (B) Remove flywheel.
INSTALLED.
113
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals