Overhaul of Camshaft

Table 6-33. Camshaft and Throttle Control Cross Shaft and Fuel Injection Pump Linkage

Repair

Disassembly

Cleaning

Inspection

Component

Assembly

Camshaft and

Associated

Parts

through

Fig. 6-214

through 6-207

6-213

Throttle Con-

trol Cross

through

Shaft and Fuel

through 6-215

Injection Pump

6-220

Linkage

6-44. Overhaul of Camshaft

following instructions which accompany figures

a. Disassembly. Disassemble camshaft

6-207 through 6-213.

Install

Remove

1. Position rubber hose on camshaft drive abaft flange

1. Remove lifting eye (A), preformed hose, and in-

and install two hose clamps (D).

tercylinder hose flange, and separate the liiting eye and

2. Position a new camshaft end cover plate gasket (C) on

flange from hose.

camshaft.

2. Remove the remaing four groups of intercylinder hose

3. Position two intercylinder hose flanges (B) on each of

flanges (B) and preformed hoses and separate tbe

four preformed hoses and position hose assemblies on

flanges from hoses.

camshaft.

3. Remove and discard the camshaft end cover plate

4. position lifting eye (A) and remaining intercylinder

gasket (C).

hose flange on remaining preformed hose and position

4. Remove two hose clamps (D) and the rubber hose

hoee assembly on camshaft.

from camshaft drive shaft flange.

Figure 6-207. Removing or installing lifting eye, intercylinder hose

flanges, and hoses.

6-174