Figure 6-216. Removing camshaft end plate ball bearing

6-45.

Overhaul

Throttle

Control

Cross

Shaft

and

Fuel

Injection

Pump

Linkage

a. Disassembly. Disassemble throttle control

cross shaft and fuel injection pump linkage

following instructions which accompany figures

6-215

through

6-220.

Remove

1. Remove camshaft end plate bearing inner retaining

ring (A).

2. Remove cap screw (B) and lock washer (or assembled

washer bolt).

3. Remove control lever (C) from cross shaft.

4. Remove cross shaft bracket bearing retaining ring and

bracket (D) with bearing as shown in figures 6-215 and

6-216.

Remove

5. Remove cross shaft lever bearing retaining ring and

1. Place the throttle control cross shaft and fuel injection

lever (E) with two bearings as shown in figures 6-215

pump linkage (A) in a soft-jawed vise.

and 6-216.

2. Remove retaining ring (B).

Install

3. Remove ball bearing (C) as shown in figure 6-216.

1 . Install cross shaft lever (E) with bearings, and

Install

retaining ring as shown in figure 6-215.

1. Place the throttle control crow shaft and fuel injection

2 . Install cross shaft bracket (D), with bearing, and

pump linkage (A) in a soft-jawed vise.

retaining ring as shown in figure 6-215.

2. Install ball bearing (C) on cross shaft.

3. Install control lever (C) on cross shaft.

3. Install retaining ring (B).

4. Install cap screw (B) and lock washer.

5. Install camshaft end plate bearing inner retaining ring

Figure

6-215.

Removing

installing

(A).

camshaft end plate ball bearing

Figure 6-217. Removing or installing cross

retaining

ring

and

ball

bearing.

shaft levers and bracket.

Figure

6-216.

Removing camshaft

end

plate

ball bearing.

6-181