Figure 6-218. Removing or installing cross shaft shock spring and control lever

Disassemble

1. Remove cap screw (A) and lock washer (or assembled

washer bolt).

2. Remove intermediate throttle lever (B) and Woodruff

key from intermediate support shaft

Remove

3. Remove two retaining rings (C).

1. Remove retaining ring (A).

4. Remove intermediate throttle lever support (D) from

2. Remove one shock spring spacer (B).

intermediate support shaft.

3. Remove shock spring (C).

5. Remove two retaining rings (E) and two ball bearings

4. Remove remaining shock spring spacer (D).

from lever support.

5. Remove cap screw (E) and lock washer (or assembled

Assemble

washer bolt).

1. Position two ball bearings in intermediate throttle

6. Remove shock spring control lever (F).

lever support (D) and install two retaining rings (E).

7. Remove Woodruff key (G) from cross shaft.

2. Position lever support (D) on intermediate support

Install

shaft.

1. Position Woodruff key (G) in cross sbaft.

3. Install two retaining rings (C).

4. Position Woodruff key and intermediate throttle lever

2. Position shock spring control lever (F) on cross shaft.

3. Install cap screw (E) and lock washer.

(B) on intermediate support shaft.

4. Position one shock spring spacer (D) on shaft.

5. Install cap screw (A) and lock washer.

5. Position shock spring (C) on shaft with both ends of

Figure

6-219.

Disassembling

assembling

spring engaging straight pin in control lever (F).

intermediate

throttle

lever

support.

6. Position remaining shock spring spacer (B) on shaft

7. Install retaining ring (A).

Figure 6-218. Removing or installing cross

shaft

shock

spring

and

control

lever.

6-182