Figure 6-192. Pressing drive gearshaft ball bearing on drive gearshaft

1. Position drive gearshaft ball bearing (A) on drive

gearshaft.

2. Carefully press ball bearing on gearshaft.

Figure 6-192. Pressing drive gearshaft ball

bearing

drive

gearshaft.

1. Position advance vane housing (A), with vane and

seals (fig. 6-183), on advance vane housing cover.

2. The alinement dots on gearshaft spline (B) must aline

with the dots on the vane spline (C).

3. The vane must have end clearance of 0.00l-inch. If

vane splines (C) have a snug fit on the accessory drive

gearshaft splines (B), insert a 0.001 inch feeler gage

between vane and vane housing cover. Gently tap vane

until proper end play is obtained, then remove feeler

gage.

4. Mate dowel pin holes (D) in vane housing with dowel

pins (E) in cover and housing bolt holes (F) with cover

bolt holes (G). Tap housing lightly with a soft hammer

to seat dowel pins.

Note. Dowel pins and dowel pin holes will

aline in two positions. However, the bolt holes in

cover and housing will aline in one position only.

Make certain that cover and housing are

correctly positioned so that bolt holes are alined.

Figure 6-193. Installing advance vane

housing and vane.

6-161