Figure 6-184. Removing rear bearing support using suitable gear puller.

1. Remove bevel gearshaft ball bearing (A) from ac-

cessory drive bevel gearshaft.

2. Remove shim (B) located behind bearing and retain

for use during assembly.

Remove

Figure 6-185. Removing accessory drive

1. Partially separate advance vane and housing and

bevel gearshaft ball bearing using

remove eight seals and springs (A)

suitable gear puller.

2. Remove vane (B) from housing.

Install

1. Position advance vane (B) in housing.

2. With vane partially separated from housing, install

Figure 6-183. Removing or installing

automatic advance vane, housing,

seals, and springs.

Figure 6-184. Removing rear bearing

support using suitable gear puller.

6-150