Figure 6-194. Installing flyweight housing

1. Install two flyweights on adjusting ring with flyweight

pins (A) installed. Flyweights must be installed in their

original positions to assure proper operation.

1. Position flyweight housing on advance vane housing.

2 . Hook flyweight extension helical springs (B) to

2. Mate dowel holes (A) with dowel pins (C) and bolt

flyweights.

holes (B) with bolt holes (D). (Refer to note fig. 6-193.)

3 . Spread flyweights against springs and install oil

3. Tap flyweight housing lightly with a soft hammer to

control housing in adjusting ring so the slots in control

seat dowel pins.

housing are alined with flyweight pins.

4 . Install the assembled adjusting ring, oil control

h o u s i n g , and flyweights on accessory drive bevel

Figure

6-194.

Installing

flyweight

housing.

gearshaft (C). Oil hole (D) in lower groove of oil control

housing must aline with dot in gearshaft (C).

Figure

6-195.

Installing

advance

flyweight

adjusting

ring

and

flyweight.

6-162