Figure 6-190. Pressing bevel gear-shaft ball bearing on gearshaft

(3) Fuel

injection

pump

advance

assembly. Refer to figures 6-191, 6-192, 6-181,

6-193

through

6-198,

6-174

and

6-173.

1. Position shim (A) of predetermined thickness (fig. 6-

189) on bearing hub of accessory drive gearshaf.

2. Position bevel gearshaft ball bearing (B) on hub, with

bearing trademark facing away from gearshaft.

3. Press bearing on gearshaft.

Note. Install rear bearing support (fig. 6-

184) on bearing using a soft faced hammer.

1. Place accessory drive bevel gearshaft (A) in a soft

jawed vise.

Figure

6-190. Pressing bevel gear-shaft

ball

2. Install vane housing cover (B) on gearshaft until it

exposes the retaining ring groove.

bearing on gearshaft.

3. Install retaining ring (C) in groove. Pull cover (B)

f o r w a r d until retaining ring is seated in the cover

retaining ring groove.

(2) Rear fan drive clutch assembly. R e f e r

for

appropriate

clutch

assembly

Figure 6-191. Installing advance vane

sequence.

housing cover on accessory drive

bevel

gearshaft.

6-160