|
|
(1) Figure 94. (A) Remove damaged, worn,
or out-of-round pilot bearing. Install
new bearing using a 0.7503-inch od bush-
ing installer. (B) Clean driven member
wearing surface on flywheel using cro-
cus cloth dampened in dry-cleaning sol-
vent or mineral spirits paint thinner.
Inspect surface for heat cracks, scor-
ing, and discoloring, caused by clutch
slippage. When flywheel clutch surface
is damaged and cannot be repaired by
polishing, the flywheel must be replaced.
Replace flywheel as directed in para-
Note. Length of new pilot bearing is
1.20 inches.
c. Installation. Install clutch driven member
and-clutch cover assembly as follows.
(1) Figure 96. (A) Position clutch driven
member assembly against flywheel with
long end of drive hub away from fly-
wheel. (B) Aline splines of driven mem-
ber hub with bushing-type pilot bearing
bore using a universal clutch alinement
tool. Do not remove alinement tool
until clutch cover is installed (fig. 97).
Note. Before positioning clutch cover
assembly against driven member, lay
cover assembly face down against flat
surface. Depress each clutch release
lever, one at a time, and place a clutch
release lever spacer block (fig. 35)
between lever and cover as shown. This
ING INSTALLATION INSTRUCTIONS .
will prevent distorting or damaging
clutch cover when cover attaching
(2) Refer to figure 95 and check edge of
screws are drawn tight to secure clutch
bearing. Edge of bearing must be flush
cover assembly to flywheel.
with flange on crankshaft.
85
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |