FIGURE 93. INSTALLING NEW CLUTCH FACINGS AND/OR CHECKING DRIVEN MEMBER RUNOUT

(5) Figure 93. (A) Position new clutch fac-

ings against driven plate with counter-

sunk side of rivet holes out, away from

plate. (B) Install 30 new 9/64 x 9/32

rivets and star set as shown.

Note. Check driven member between

two parallel surfaces spaced 0.440- inch

apart. It must rotate freely without

frictional drag and have no more than

0.025- inch runout.

b. Bushing-Type Pilot Bearing. With the

clutch assembly removed, inspect driven mem-

ber wear surface on flywheel and condition of

bushing-type pilot bearing in end of crankshaft.

Remove pilot bearing and inspect wear surface

on flywheel as follows.

Note. This composition type (OILITE) bearing

can be easily damaged during installation. When

bearing is chipped or cracked during installation,

replace the bearing. Lubricate the pilot bearing

with a small amount of high melting point

grease (BR) (Spec. 14-L-3C). Do not overgrease.