Overhaul of Generator Air Intake and Exhaust Tubes and Associated Parts

b. Cleaning, Inspection, and Repair. Refer to

Overhaul of Generator Air Intake

paragraphs 6-2 through 6-4.

and Exhaust Tubes and Associated

c. A s s e m b l y . R e f e r t o f i g u r e

The

Parts

generator boot, exhaust tube, and associated

a. Disassembly. Disassemble generator air

parts are assembled during engine assembly,

intake tube assembly following instructions

which

accompany

The

generator

boot exhaust tube, and associated parts were

disassembled during disassembly of engine,

Disassemble

1. Remove six cap screws (A) and lock washers attaching

screen to hose elbow.

2. Remove screen (B).

3. Remove and discard screen gasket (C).

4. Loosen two hose clamps (D) and remove hose from

generator air intake tube and elbow. Remove clamps

from hose.

Assemble

1. Position two hose clamps (D) on hose. Position hose

on elbow and generator air intake tube and tighten hose

clamps.

2. Position a new screen gasket (C) on elbow.

3. Position screen (B) on elbow.

4. Install six cap screws (A) and lock washers securing

screen to elbow.

Figure 6-250. Disassembling or assembling

generator air intake tube assembly.

6-212