 |
|||
|
|
|||
|
Page Title:
Figure 5-168. Removing or installing oil seal housing support. |
|
||
| ||||||||||
|
|
 main bearing crankcase tie rod nuts before
Remove
1. Remove four cap screws (A) and flat washers at-
removing support. Refer to figure 5-171.
taching oil seal housing support (B) to crankcase
Install
assembly.
1. Position oil seal housing support (B) on dowel pins
2. Remove support from dowel pins (fig. 5-169) in
(fig. 5-169) in crankcase.
crankcase.
2. Install four cap screws (A) and flat washers securing
3. Remove and discard candlewick packing (C).
support to crankcase assembly.
3. Install new candlewick packing (C).
Note. It may be necessary to loosen No. 7
5-96
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals