Crankshaft and Connecting Rod Assembly, Piston Oiler Nozzles, Generator and Starter Idler Gears, and Starter Driven Gearshaft

1. Install three 7/16 x 1-1/8 in. accessory drive gear

mounting bolts (A) in tapped holes provided in ac-

cessory drive gear.

Remove

Z. Alternately tighten bolts (B) and pull accesory drive

1. Cut locking wire (A).

gear from flange on crankshaft. Remove puller bolts

2. Remove 12 bolts (B) attaching accessory drive gear to

from gear.

flange on crankshaft.

Install

Figure 5-170. Removing accessory drive gear

1. Install 12 bolts (B) securing accessory drive gear to

using mounting bolts as puller screws.

flange on crankshaft.

2. Install locking wire (A) securing bolts.

Figure 5-169. Removing or installing acces-

sory drive gear attaching parts.

5-15. Crankshaft and Connecting Rod

R e f e r to Table 5-12 for illustrations and

Assembly,

Piston

Oiler

Nozzles,

disassembly instructions. Figure references are

Generator and Starter Idler Gears, and

listed in the table.

Starter Driven Gearshaft

Table 5-12. Crankshaft and Connecting Rod Assembly, Piston

Oiler Nozzles, Generator and Starter Idler Gears,

and Starter Driven Shaft

Crankshaft and Connecting Rod Assembly and Piston Oiler

Nozzles

Generator and Starter Idler Gears and Starter Driven

Gearshaft

5-97