Figure 5-167. Removing or installing oil seal cap and housing.

Remove

1. Cut locking wire and remove four slotted nuts (A) and

flat washers attaching oil seal cap to oil seal housing.

2. Cut locking wire and remove 20 drilled head bolts (B)

and flat washers attaching oil seal cap and housing to

crankcase assembly.

Install

1. Install 20 drilled head bolts (B) and flat washers

securing oil seal cap and housing to crankcase

assembly. Install locking wire securing bolts.

2. Install four slotted nuts (A) and flat washers securing

oil seal cap to oil seal housing. Install locking wire

securing nuts.

Figure 5-166. Removing or installing

crankshaft oil seal cap and housing

attaching parts.

Rem ove

Note. Free the oil seal cap and housing from

d o w e l pins by tapping edges of the oil seal cap

and housing with a soft faced hammer.

1. Separate and remove oil seal cap and housing (A).

2. Remove and discard oil seal cap and housing gasket

(B).

N o t e . The oil seal housing is machined with

the crankcase and is a mating part. Always keep

oil

seal

housing

with

the

crankcase

was

removed

from.

Install

1. Position a new oil seal cap and housing gasket (B) on

crankcase assembly.

2. Position oil seal cap and housing (A) around

crankshaft and on locating dowel pins in crankcase

assembly and housing.

Figure 5-167. Removing or installing oil

seal cap and housing.

5-95