Section VIII. OVERHAUL (REBUILD) OF REVERSE-RANGE PLANETARY CARRIER ASSEMBLY

Section VIII. OVERHAUL (REBUILD) OF REVERSE-RANGE

PLANETARY CARRIER ASSEMBLY

NOTE

(rebuild ) points of measurement for fits, clearances,

If the assembly is worn or damaged such

and wear limits are indicated by small letters in

that the operations below will not restore it

figure 5-75. Refer to paragraph 6-3 and table 6-3

for general wear limits information.

to serviceable on, replace entire assembly.

5-32. Description

5-36. Assembly

(fig. 5-75)

Refer to paragraph 2-5 for description of the

reverse-range planetary carrier assembly.

NOTE

All items not covered in a through c below

5-33. Disassembly

are installed as outlined in paragraph 5-58,

(fig. 5-75)

steps 3 through 10 (fig. 5-85 through 5-

NOTE

92). No overhaul (rebuild) of such com-

All items not covered below were removed

ponents is required or recommended.

from the transmission as outlined in

a. If rear pitot collector ring (29) is being

paragraph 5-6, steps 46 through 50 (fig. 5-

replaced, place ring on hub side of carrier (32) with

46 through 5-50). No further disassembly

large opening up.

of those parts is required. If rear pitot

b. Install three washers (31) on three rivets (30),

collector ring (29) is damaged in any way,

and insert rivets through collector ring and into

press out three riveta (30), and remove

carrier.

collector ring and three washers (31) from

c. Support rivet heads and, using a press, cold-

reverse-range planetary carrier (32).

form head on flat side of carrier to 0.030-inch

5-34. CIeaning

minimum height with approximately 6 tons press

load per rivet.

Refer to paragraph 5-2 for cleaning recom-

mendations.

d. Using oil-soluble grease to retain it, install

thrust washer (19) into counterbore at front of

5-35. Inspection and Repair

carrier assembly (21).

Refer to paragraph 5-3 for general inspection and

repair recommendations. Repair and overhaul

5-35