Section IX. OVERHAUL (REBUILD) OF TRANSMISSION OUTPUT SHAFT ASSEMBLY

Section IX. OVERHAUL (REBUILD) OF TRANSMISSION OUTPUT SHAFT ASSEMBLY

outlined in paragraph 5-58, steps 14

NOTE

through 16 (fig. 5-96 through 5-98). No

If the assembly is worn or damaged such

overhaul (rebuild) of such components is

that the operation below will not restore it

required or recommended. If bushing (44),

to serviceable condition, replace entire

was removed, install new bushing using

assembly.

replacer 5120-759-5415 and handle 5120-

5-37. Description

316-9182. Drive until replacer bottoms

Refer to paragraph 2-10 for description of the

against output shaft (fig. 5-79).

transmission output shaft assembly.

5-38. Disassembly

(fig. 5-74)

NOTE

All items not covered below were removed

from the transmission as outlined in

paragraph 5-6, steps 42 and 43 (fig. 5-42

and 5-43). No further disassembly of those

parts is required. If bushing (44) is worn or

damaged s u c h that replacement is

necessary, remove bushing from bore. Do

not damage bushing bore when removing

bushing.

5-39. Cleaning

Refer to paragraph 5-2 for cleaning recom-

mendations.

5-40. Inspection and Repair

Refer to paragraph 5-3 for general inspection and

repair recommendations. Repair and overhaul

(rebuild) points of measurement for fits, clearances,

and wear limits are indicated by sm all letters in

figure 5-74. Refer to paragraph 6-3 and table 6-3

for general wear limits information.

5-41. Assembly

(fig. 5-74)

NOTE

All items not covered below are installed as

TRANSMISSION HOUSING ASSEMBLY

Section X. OVERHAUL (REBUILD) OF

a. Do not remove shift lever sleeve (fig. 5-80)

5-42. Description

from transmission housing unless replacement is

Refer to paragraph 2-8 for description of the

necessary. If necessary, remove by driving sleeve

transmission housing assembly.

from inside of housing to outside. Be careful not to

5-43. Disassembly

damage sleeve bore.

(fig. 5-81)

b. Do not remove speedometer bushing (6) from

NOTE

transmission housing (8) unless replacement is

All items not covered in sand b below were

necessary. If necessary to remove bushing, be

removed from the transmission as outlined

careful not to damage bushing bore. In some

in paragraph 5-6, steps 50 and 51 (fig. 5-50

transmission this bushing will not be used because a

and 5-51). No further disassembly of those

speedometer drive is not required.

parts is required.

5-36