INJECTOR, FUEL.

TM 55-1930-208-24

g. Installation.

(1) Refer to figure 3-45 and install new gasket (4) to pump mounting flange. Install drive coupling

fork (5) on shaft.

(2) Place the fuel pump (3) against the blower, being certain that the drive coupling fork registers

with the slots in the drive disc on the blower rotor shaft.

(3) Install and tighten three lockwashers (2) and three screws (1).

3-22. INJECTOR, FUEL.

This task covers:

a. Removal

b. Test

c. Disassembly

d. Cleaning

e. Inspection

f. Repair

g. Reassembly

h. Installation

INITIAL SETUP:

Tools Required:

Tool Kit, General Mechanic's (Item 1, Appendix B)

Socket, Injector Nut (Item 8, Appendix B)

Remover, Injector (Item 9, Appendix B)

Reamer, Hand (Item 10, Appendix B)

Socket, Injector Nut (Item 11, Appendix B)

Driver, Spray Tip (Item 12, Appendix B)

Spray Tip Orifices Cleaning Tool (Item 13, Appendix B)

Spray Tip, Cleaning Tool (Item 14, Appendix B)

Wire, Orifice Cleaning .005 In. Diameter (Item 15, Appendix B)

Wire, Orifice Cleaning .006 In. Diameter (Item 16, Appendix B)

Stone (Item 17, Appendix B)

Brush, Fuel Hole (Item 18, Appendix B)

Brush, Rock Hole (Item 19, Appendix B)

Reamer (Item 20, Appendix B)

Tester, Fuel Injector (Item 21, Appendix B)

Fuel Output Tester (Item 22, Appendix B)

Tester, Rack (Item 23, Appendix B)

Reamer (Item 24, Appendix B)

Wrench, Torque (Item 71, Appendix B)

Materials Required:

Caps, Line (for fuel lines)

Filter Element P/N 5228587

Gasket P/N 5229167

Solvent, Cleaning (Item 4, Appendix C)

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

Rocker cover removed (paragraph 3-34).

3-81