BLOWER DRIVE. - TM-55-1930-208-240088

TM 55-1930-208-24

g. Installation. (Refer to figure 3-26).

(1) Use adhesive (item 1, Appendix C) and install gasket (4) to the engine block.

(2) Install blower drive shaft cover (6) and secure with clamp (5).

(3) Place blower (3) into position against the cylinder block, being careful not to dislodge the blower

gasket.

(4) Install eight blower mounting bolts (1) and eight flat washers (2).

(5) Install fresh water pump (paragraph 3-25).

(6) Install fuel pump (paragraph 3-22).

(7) Install air inlet housing (paragraph 3-18).

(8) Install air cleaners (paragraph 3-15, TM 55-1930-208-10).

(9) Install blower drive shaft (paragraph 3-21).

(10) Install hydraulic speed control governor (paragraph 3-17).

(11) Fill cooling system with coolant per paragraph 3-20, TM 55-1930-208-10, start engine and check

operation.

3-20.

BLOWER DRIVE.

This task covers:

a. Removal

b. Disassembly

c. Cleaning

d. Inspection

e. Repair

f. Reassembly

g. Installation

INITIAL SETUP:

Tools Required:

Tool Kit, General Mechanics (Item 1, Appendix B)

Wrench, Torque (Item 71, Appendix B)

Materials Required:

Gasket P/N 5148810

Oil, Engine (Item 8, Appendix C)

Solvent, Cleaning (Item 4, Appendix C)

Washer, Lock P/N MS35338-46)

Equipment Conditions:

Engine shut down (paragraph 2-11, TM 55-1930-208-10).

3-71