Figure 3-2. Clamping Configuration for Contents Stored in Weapon Security Cage XH4289.

TM 9-8140-381-14&P

h. Tighten all four screws beginning with the

k. To return WSC to original configuration, raise

cover and remove the five screws beginning

shoulder screws and springs.

with the 6-32 cap screws.

i. Insert locking bar through bracket and tang

3-3.

INTERNAL CONFIGURATION

receptacle. Ensure padlock holes align. Within

OF WSC

tang receptacle, install a 6-32 cap screw into

locking bar using a 3/32-inch allen wrench ball

Due to the original design of the WSC, the as issued

driver.

WSC provides an open rectangular area (internal area)

approximately 70 x 61 x 28 inches, but is modified to

j. Close and secure cage with padlocks.

accept various clamps and tiedowns for special storage.

Changes and applications to the internal base of the

WSC (fig. 3-2) are based on the individual usage needs

NOTE

and any special clamping or tiedown can be done.

Process is fully reversible and WSC

Clamps and straps can be attached to fixtures. The

can

returned

original

clamp application can be used to hold a container in

configuration.

place. The strap application when used with tiedowns

and an extension bar/ratchet, provides securing to flat

surface.

Figure 3-2. Clamping Configuration for Contents Stored in Weapon Security Cage XH4289.

3-3