|
|
TM 9-4931-381-14&P-1
OPERATOR ASSISTED SELF TEST PROCEDURE
CHAPTER 6
OPERATOR ASSISTED SELF TEST PROCEDURE
The operator assisted self
test procedure (figures 6-1 and 6-2) is used to locate and identify
fault symptoms. It is also
used to verify a fault symptom. If the test set continues to show the
same fault symptom after
corrective maintenance has been performed, turn in the test set.
The fail codes referred to
in the procedure are listed in the fail code index (figure 6-2, table 6-3
and table 6-4).
For test set schematic diagrams, refer to FO-1
thru FO-19.
Preliminary procedures:
q Prepare the test set for operation. Refer to
Preparation for Operation, volume 1,
Figure 6-1. Preparation for Operator Assisted Self-Test (Sheet 1 of 2)
6-1
Volume Ill
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |