INSPECT PARTS FOR DAMAGE

TM 9-2835-255-34

S T A R T E R M O T O R R E P A I R ( S h e e t 2 o f 11)

b. Remove four nuts (1). Remove cover (2)

and gasket (3).

2. INSPECT PARTS FOR DAMAGE. REPLACE

AS REQUIRED.

CAUTION

Do not pull brush lead (4) while brush (5) is being

held by brush spring (6). Lead (4) may come out of

brush (5}.

3. REMOVE EIGHT BRUSHES (5) AND FOUR

LOCK PLATES (7).

a. Pull spring (6) up enough to release

brush (5). While holding spring (6) up,

pull brush (5) out of holder (8), Allow

spring (61 to return to rest.

b. Repeat step a for second brush (5) in

same window (9).

c. Remove two screws (10), one plate (7),

and two brushes (5).

d. Repeat steps a, b, and c for three

remaining `pairs of brushes (5).

4. REMOVE END HOUSING ASSEMBLY (11),

HANDLE (12), JUMPER (13), AND

PREFORMED PACKING (14).

a. Mark field ring assembly (15) and end

housing (11) with scribe.

b. Remove four screws (16), lockwashers (17),

and handle (12) from end housing (11).

c. Remove end housing (11) from ring (15).

Remove two thrust washers (18).

NOTE

Model MC has built in jumper (13). If working on

model MC, do step d.

d. Note position of jumper (13) and remove

from end housing (11).

e. Remove packing (14) from end housing

(11).

Go on to Sheet 3

9-52