 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9-2835-255-34
ACCESSORY GEARBOX CLEANING AND REPAIR (Sheet 31 of 40)
NOTE
If gasket (1) or spacer (2) being installed
are not the same that were removed, do
steps 7 through 10. If the same gasket
and spacer are being installed, skip steps
7 through 10 and go to step 11 (page
7. MEASURE THICKNESS OF COVER (3) AT OIL
PUMP PAD (4) AND RECORD AS DIMENSION A.
a.
Turn cover (3) over on work surface (5) using
care not to rest cover on oil scavenge tube
(6).
Hold measuring bar (7) firmly against cover
b.
mating surface (8) under oil pump pad (4).
c.
Measure from oil pump pad (4) to measuring
bar (7) with depth gage. Record as dimen-
sion A.
d. Turn cover (3) over on work surface (5).
NOTE
Make sure spur gearshaft assembly is
seated all the way in housing.
8. PLACE SPUR GEARSHAFT ASSEMBLY (9) IN
HOUSING (10), MEASURE AND RECORD THICK-
NESS OF NEW GASKET (1), AND TAPE NEW GAS-
KET (1) IN PLACE ON HOUSING (10).
a.
Place spur gearshaft assembly (9). Pin end
down, in bore (11) of housing (10).
NOTE
If gasket (1) should get damaged during
assembly, use new gasket and go back
to step 7.
b.
Place gasket (1) on housing (10) and hold in
place using tape.
Go on to Sheet 32
7-76
Change 6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals