TUBE ASSEMBLY AND INTERNAL PRESSURE SPECIAL SEALS AND PACKING (NO. 5 AND 6 BEARING OIL FEED) REPLACEMENT (Sheet 1 of 2)

TM 9-2835-255-34

TUBE ASSEMBLY AND INTERNAL PRESSURE SPECIAL SEALS AND PACKING

(NO. 5 AND 6 BEARING OIL FEED) REPLACEMENT (Sheet 1 of 2)

TOOLS: General mechanic's tool kit: automotive (SC 5180-90-N26)

Adapter, 3/8 inch to l/4-inch (Item 33, Appendix D)

Inserted hammer face (Item 1, Appendix D)

Inserted hammer face holder (Item 2, Appendix D)

Torque adapter (Item 23, Appendix D)

Torque wrench, 0-150 in-lb (Item 27, Appendix D)

SUPPLIES:

Antiseize compound (Item 2, Appendix B)

Lubricating oil (Item 11 or 12, Appendix B)

Nonelectric wire (Item 15, Appendix B)

Packing (Item 35, Appendix E)

Shortening compound (Item 20, Appendix B)

Shoulder bolt (Item 31, Appendix E) (2 required)

Special seal (Item 33, Appendix E)

Special seal (Item 36, Appendix E)

EQUIPMENT CONDITION: Forward engine module (gearbox module attached) removed page 5-26)

REMOVAL:

1. REMOVE TUBE (l), SPECIAL SEALS (2, 3)

AND PACKING (4).

a. Cut safety wire and remove four bolts (5)

and washers (6).

b. Cut wire and remove two inner shoulder

bolts (7). Use box end of torque adapter to

remove tube (l).

c. Remove seals (2, 3) and packing (4)

NOTE

Replace hollow pins (8) only if damaged, and set

tube (1) aside.

2. INSPECT PIN (8) FOR DAMAGE. REPLACE

AS REQUIRED.

3. INSPECT PARTS FOR DAMAGE. REPLACE

AS REQUIRED.

Go on to Sheet 2

6-12

Change 2