 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
FORWARD ENGINE MODULE (GEARBOX MODULE ATTACHED) REMOVAL
AND INSTALLATION (Sheet 2 of 7)
REMOVAL:
1.
REMOVE BRACKET (l).
a. Position forward dolly (2). Turn handle (3)
clockwise until dolly (2) is all the way in.
b. Unhook two latches (4).
c. Remove three bolts (5). Remove
bracket (l).
2.
REMOVE TWO BOLTS (6). LOWER
JACK (7).
3.
INSTALL FORWARD ENGINE MODULE
LIFTING SLING (PAGE 5-12).
CAUTION
Do not lean on, or hang anything on shaft (8).
q
Damage to bearing seal or air seal may result.
Make sure plug (9) does not hit front plate (10)
q
when forward module (11) is moved.
4.
REMOVE FORWARD MODULE (11) FROM
REAR MODULE (12).
a. Remove 81 bolts (13) and self-locking
nuts (14).
b. Remove 15 self-locking nuts (15) from
studs (16).
c. Apply oil to tap and clean out four
jackscrew holes (17), located at the 12, 3,
6, and 9 o'clock positions.
d. Apply oil to four .iackscrews (18), Install
jacksrews (18) in-holes (17).
NOTE
Tighten jackscrews (18) opposite each other.
e. Tighten jackscrews (18) evenly until
forward module (11) moves away from
rear module (12). Remove jackscrews (18).
f. Turn handle (3) counterclockwise until
forward module (11) stops at end of stand
(19).
g. Remove gasket (20).
Go on to Sheet 3
5-26
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals