 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
NO. 2 AND 3 BEARING SEAL/PACKING RETAINER REPLACEMENT (INCLUDING INTERSHAFT SEAL)
(Sheet 5 of 49)
With inlet housing (2) facing up, make
sure dirt or any foreign objects do not fall
into forward engine module. Damage to
components may result.
2.
REMOVE ACCESS COVER (1) AND PACKING (4).
a.
Block inlet housing (2) with clean rags (5) to
prevent dirt or objects from falling into forward
engine module (3).
b.
Cut safety wire and remove three bolts (6),
access cover (1) and preformed packing (4)
from inlet housing (2). Discard packing (4).
3.
REMOVE NO.1 BEARING HOUSING (7).
a.
Cut safety wire and remove six bolts (8) from
bearing housing (7).
b.
Using three bolts (9), removed from access
cover in step 2 as jacking screws, install bolts
(9) into three threaded holes (10). Tighten
bolts (9) evenly opposite each other until bear-
ing housing (7) is away from inlet housing (2).
LE5551
Go on to Sheet 6
5-79
Change 6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals