 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
NO. 1 BEARING SEAL/PACKING RETAINER REPLACEMENT (Sheet 6 of 21)
CAUTlON
The No. 1 bearing (1) is comprised of four
separate pieces which will fall apart. Do
not handle bearing parts with bare hands.
Damage to bearing may result. Use clean
cotton gloves.
6. REMOVE NO. 1 BEARING (1) FROM SLEEVE
BUSHING (2).
7. REMOVE INLET HOUSING (3) FROM LOW PRES-
SURE ROTOR AND HOUSING ASSEMBLY (4).
a.
Disconnect plug connector 3W105-P34 (5)
from temperature rotor sensor receptacle con-
nector J34 (6).
b.
Disconnect No. 1 bearing oil feed tube (7)
from fitting (8). Remove and discard flared
sleeve (9). Disconnect scavenge tube (10)
from fitting (11). Remove and discard com-
pression sleeve (12).
c.
Install protector caps on all open ends of fit-
tings.
--
d.
Using marker, place a match mark line (13) on
inlet housing (3) and forward flange of low
pressure rotor and housing assembly (4).
Go on to Sheet 7
Change 6
5-59
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals