REMOVE NO. 1 BEARING AND SLEEVE BUSHING

TM 9-2835-255-34

NO. 1 BEARING SEAL/PACKING RETAINER REPLACEMENT (Sheet 5 of 21)

4. REMOVE NO. 1 BEARING AND SLEEVE BUSH-

ING (1) FROM INLET HOUSING (2).

Using three bolts (3) as jacking screws, install

bolts (3) into three threaded holes (4) of

sleeve bushing (1).

CAUTION

The No. 1 bearing is comprised of four

separate pieces which will fall apart. Do

not handle bearing parts with bare hands.

Damage to bearing may result. Use clean

cotton gloves.

b. Tighten bolts (3) evenly opposite each other

until sleeve bushing (1) is away from inlet

housing (2).

Remove and discard preformed packings (5)

and (6).

5. REMOVE NO. 1 BEARING INNER RACE HALF (7)

WITH RING SPACER (8) FROM LOW PRESSURE

COMPRESSOR SHAFT (9) USING BEARING PULLER

(10).

LE554

Go on to Sheet 6

Change 6

5-58