REMOVE PLAIN ROUND NUT - TM-9-2835-255-340429

TM 9-2835-255-34

NO. 1 BEARING SEAL/PACKING RETAINER REPLACEMENT (Sheet 4 of 21)

Remove jacking screws (1), bearing housing

(2) and ring spacer (3) from inlet housing (4).

Retain ring spacer (3) for further use.

Remove and discard two preformed packings

(5) from bearing housing (2).

3. REMOVE PLAIN ROUND NUT (6), PACKING

RETAINER (7) AND SLEEVE SPACER (8) FROM

INLET HOUSING (4).

Using suitable tool, uncrimp packing retainer

(7).

NOTE

Locking cup holding fixture (9) has an

"offset hole" which shall be at 7 o'clock

position when properly installed.

Place locking cup holding fixture (9) on inlet

housing (4) and make sure tangs of holding

fixture (9) engage packing retainer (7).

Align offset holes of holding fixture (9) on inlet

housing (4) at the 7 o'clock position.

Secure holding fixture (9) to inlet housing (4)

with six bolts (10).

Using spanner wrench (11), remove plain

LE553

round nut (6).

Remove and discard packing retainer (7).

Remove holding fixture (9).

Remove sleeve spacer (8) and set aside.

Go on to Sheet 5

Change 6

5-57