 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
NO. 1 BEARING SEAL/PACKING RETAINER REPLACEMENT (Sheet 3 of 21)
REMOVAL:
1.
REMOVE ACCESS COVER (1).
a.
Cut safety wire and remove three bolts (2),
access cover (1), and preformed packing (3)
from inlet housing (4). Discard packing (3).
2.
REMOVE NO. 1 BEARING HOUSING (5).
a.
Cut safety wire and remove six bolts (6) from
bearing housing (5).
b.
Using three bolts (2) removed from access
cover (1) as jacking screws, install bolts (2)
into three threaded holes (7). Tighten bolts (2)
evenly and opposite each other until bearing
housing (5) is away from inlet housing (4).
Go on to Sheet 4
Change 6
5-56
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals