POSITION STOP PLATE

TM 9-2835-255-34

LOW PRESSURE ROTOR AND HOUSING ASSEMBLY (COMPRESSOR) AND HIGH PRESSURE

AXIAL COMPRESSOR AND ROTOR CLEANING (Sheet 21 of 21)

45.

ALINE HOLE IN LEVER (1) WITH SLOT IN

LINK (2) AND INSTALL BOLT (3),

WASHER (4), SPACER (5) AND NEW NUT

(6).

46.

POSITION STOP PLATE (7) ON FLANGE

(8) AND INSTALL TWO NEW NUTS (9).

TORQUE NUTS (9) BETWEEN 100-110

IN-LB (11-12 N.m).

NOTE

Make sure mending plates (10) are positoned on

flats of union fitting (11).

47.

INSTALL TWO SPACERS (12), TWO

MENDING PLATES (10), AND TWO

BOLTS (13) ON HOUSING (14).

48.

INSTALL NEW FLARED CONICAL SEAL

(15) ON FI'IT'ING (11). INSTALL TEE (16)

ON FITTlNG (11) AND TIGHTEN NUT (17).

49.

INSTALL TEMPERATURE ROTOR

SENSOR PLUG (TM 20-1).

INSTALL BLEED VALVE ROD (TM 20-1).

50.

INSTALL ACCESSORY GEARBOX MOD-

51.

ULE (PAGE 7-6).

INSTALL IGN1TION ELECTRICAL LEAD

52.

(TM 20-1).

INSTALL TUBE ASSEMBLY (NO. 2 AND 3

53.

BEARINGS) (TM 20-1).

INSTALL PRESSURE FLUID FILTER

54.

DOUBLE ANGLE BRACKET (TM 20-1).

End of Task

5-54 Change 4