INSTALL LEVER AND SHAFT

TM 9-2835-255-34

LOW PRESSURE ROTOR AND HOUSING ASSEMBLY (COMPRESSOR) AND HIGH PRESSURE

AXIAL COMPRESSOR AND ROTOR CLEANING (Sheet 20 of 21)

42. INSTALL LEVER AND SHAFT (1) ON

LOW PRESSURE CASE AND STATOR

ASSEMBLY (2).

a. Position shaft (3) in hole (4) in case and

stator assembly (2).

b. Aline hole (5) in shaft (3) with hole (6) in

case and stator assembly (2). Install bolt

(7) and new nut (8).

43. TORQUE BOLT (7) AND NUT (8) BE-

TWEEN 100-110 LB-IN (11-12 Nm).

44. INSTALL BRACKET (9) AND CYLINDER

AND BRACKET (10).

a. Apply antiseize compound to bolt (11).

Aline bracket (9) and tWO spacers (12)

under flange (13). Install bolt (11) and new

nut (14).

b. Apply antiseize compound to long bolt

(15) and short bolt (16). Position cylinder

and bracket (10) and two spacers (17) on

flange (18). Loosely install long bolt (15)

and new key washer (19).

c. Loosely install short bolt (16) and new nut

(20).

Apply antiseize compound to two bolts

(21). Install bolts (21) and new lock

washers (22). Tighten bolts (15,16) and nut

(20). Bend tabs on keywasher (19).

Go on to Sheet 21

Change 4 5-53