 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2835-255-34
INTERMEDIATE (LOW PRESSURE) HOUSING (TOP HALF) REPLACEMENT
(Sheet 3 of 6)
3. REMOVE LINK (1) AND TWO COVERS (2).
a. Remove lockpin (3) and pin (4). Move link (1)
all the way forward.
b. Remove two bolts (5). Remove covers (2) and
gaskets (6).
CAUTION
Be careful not to damage preformed packing(7)
while removing housing (8).
When working on internal parts of engine, make
q
sure dirt or any objects do not get in engine.
4. REMOVE HOUSING(8).
a. Remove 14 bolts (9) and washers (10).
b. Turn bellcrank (11) all the way left or right.
NOTE
If any vanes (12) came loose, set them aside.
c. Remove housing (8) from engine (13).
5. INSPECT PACKING (7) FOR DAMAGE IF
DAMAGED, CUT PACKING(7) EVEN WITH
FLANGE (14) ON BOTH SIDES OF ENGINE.
REMOVE PACKING (7).
6. INSPECT ALL OTHER PARTS FOR
DAMAGE.
REPLACE AS REQUIRED.
INSTALLATION:
CAUTION
Do not stretch new packing(7) when fitting it in
groove (15).
NOTE
If packing(7) was removed, do step 1.
1. INSTALL NEW PACKING(7).
a. Cut packing(7) so it becomes one length.
b. Cut packing(7) to fit in groove(15) so both
ends butt against flanges (14).
c. Apply shortening to packing (7) and install
in groove (15).
Go on to Sheet 4
5-8
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals