Section XXVII. Repair of Alternator Assembly and Mounting Bracket.

*TM 9-2815-213-34

c. Remove locknut (2) securing pulley to shaft and

Insure that flat spacer washers are

placed between pump body and

remove pulley and woodruff key (3).

d. Remove two cap screws (14) lockwasher (12)

mounting bracket.

and flat spacer washers (15) securing pump (5) to

mounting bracket (4).

3-148. Installation

a. Install pump and bracket assembly mounting

bracket on block and secure with three cap screws,

3-144. Cleaning

lockwashers and plain washers.

Clean all components in accordance with procedures in

b. Install pump and bracket assembly on engine

paragraph 2-5.

mounting bracket and secure with two cap screws,

lockwashers, and plain washers.

3-145. Inspection

c. Install pump drive belt on pulley.

Perform general inspection

accordance

with

d. Install tension adjusting strap on engine block

paragraph 2-6.

with cap screw, lockwasher and plain washer. Finger

tighten.

3-146. Repair

e. Secure tension adjusting strap to pump

Repair of the pump and brackets is limited to the

mounting bracket with cap screw, lockwasher, and plain

instructions contained in paragraph 2-7.

washer.

f. Adjust pump to obtain proper belt tension and

3-147. Assembly

tighten tension strap to block securing cap-screw.

Refer to paragraph 3-143 and reverse procedures to

assembly the pump.

NOTE

Section XXVII. Repair of Alternator Assembly and Mounting Bracket.

3-149. Disassembly

3-152. Repair

(fig. B-24)

Repair of the alternator and bracket is limited to the

a. Remove locknut from shaft and remove two

instructions of paragraph 2-7. The alternator shall be

replaced if noisy or voltage cannot be maintained

sheave pulley and key.

b. Remove cap screw and lockwasher securing

between 27-29 volts.

adjusting arm to alternator end plate.

3-153. Assembly

Refer to paragraph 3-149 and reverse disassembly

3-150. Cleaning

procedures.

Clean all components in accordance with procedures in

paragraph 2-5.

3-154. Installation

3-151. Inspection

Refer to paragraph 2-lO.c.,

and reverse removal

Perform general inspection in accordance with the

procedures.

requirements of paragraph 2-6.

Section XXVIII. Repair of Starter Assembly

3-155. Inspection and Repair

3-156. Installation

Refer to TM 9-2920-242-34 for inspection and repair

Refer to paragraph 2-10.a.,

and reverse removal

procedures, and repair parts listing.

procedures.

Section XXIX. Repair of Oil Cooler

(14) and filter element (15).

3-157. Disassembly

(fig. B-1l)

a. Remove transmitter (16) and bushing (17) from

3-158. Cleaning

a. Oil Side.

pipe tee (18).

b. Remove pipe plug (5) and (10).

c. Remove five cap screws (23) and lockwasher (7)

CAUTION

securing cover (12) to housing (22).

Perform the following operation in a well

d. Remove gasket (13) O-Rings (24) retainer

ventilated area to avoid toxic effect of

chemicals being used.

3-56