 |
|||
|
|
|||
|
Page Title:
FIGURE 165. REMOVING CRANKSHAFT REAR OIL SEAL FROM HOUSING |
|
||
| ||||||||||
|
|
 b. Installation. Install crankshaft rear oil
seal and oil seal housing as follows.
(1) Figure 166. (A) Position crankshaft rear
oil seal housing, gasket surface down, on
press table as shown. (B) Start crank-
shaft rear oil seal into "housing making
sure oil seal lip is facing housing gas-
ket surface as shown in figure 167.
(C) Install oil seal into housing using a
suitable pressing plate having a slightly
smaller diameter than the oil seal cas-
ing.
116
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals