 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 6-11.
Rebuild
of
Starter
Drive
a.
Disassembly. Disassemble starter driven
gearshaft following the sequence of instructions
in figures 6-19 and 6-20.
Note. If the engine is equipped with a bearing
cage that does not have a groove on the pilot
diameter
for
the
installation
of
a
preformed
packing, discard this bearing cage. Although
both the old and new bearing cages maintain the
same part number 8761022, only the late
bearing cage is carried through normal
replacement part channels and must be used
when
rebuilding
starter driven
gearshaft.
Preformed
packing MS 28775-236
cannot be
u s e d on a bearing cage unless there is a groove in
the cage pilot to accommodate it.
1. Press starter driven gearshaft (A) from upper ball
bearing.
2. Press gearshaft from the lower ball bearing (B) in a
similar manner.
from
ball
1. Press the starter driven gearshaft from bearing cage.
2. To remove oil seal (A), press it from the bearing cage
using a suitable arbor press. Discard oil seal.
6-19.
Pressing
starter
driven
gear-
shaft and bearings from bearing cage.
6-25
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals