Overhaul of Transmission Adapter

Table 6-3. Crankcase Standard and Oversize Stud Identification - Continued

Assembly.

(1) Preliminary instructions. Refer

general assembly procedures (para 6-6).

(2) Position crankcase. Rotate the engine

overhaul stand so the crankcase is in the upright

position.

(3) Install pipe plugs. Refer to figures 6-5

through 6-7.

6-10. Overhaul of Transmission Adapter

a. Disassembly. Disassemble transmission

adapter following the sequence of instructions

which accompany figure 6-18.

Remove

1. Cut locking wire and remove four bolts (A) attaching

lifting eye to transmission adapter. Remove lifting eye.

2. Cut locking wire and remove two bolts (B) attaching

timing pointer to adapter. Remove timing pointer.

3. Do not remove the two dowel pins (C) or the two

r e s i l i e n t mounts (D) unless inspection (para 6-3f)

shows replacement is necessary. To remove dowel pins

or resilient mounts, press from adapter using an arbor

press.

Install

1 . If dowel pins (C) or resilient mounts (D) were

removed from transmission adapter, install new parts

using an arbor press.

2. Position timing pointer on adapter and install two

bolts (B) securing pointer on adapter. Install locking

wire securing bolts.

3. Position lifting eye on adapter and install four bolts

( A ) securing eye on adapter. Install locking wire

securing bolts.

Figure 6-18. Removing or installing

transmission adapter lifting eye

and

timing

pointer.

b. Cleaning, Inspection, and Repair. Refer to

c. A s s e m b l y . Refer to figure 6-18.

6-24