Figure 5-108. Removing or installing rocker arm cover bolts and cap screws.

Disconnect

1. Remove cap screw (A) and flat washer attaching right

camshaft gear housing to rocker arm cover.

2. Do not remove two cap screws (B) and flat washers

attaching housing to cylinder until camshaft is removed

Connect

1. The two cap screws (B) and flat washers securing

right camshaft gear housing to cylinder are installed

when camshaft is installed (fig. 5-115).

Remove

2. Install cap screw(A) and flat washer securing housing

1. Remove bolt (A) attaching transmission oil cooler end

to rocker arm cover.

shroud retaining tab to cylinder No. 6R rocker arm

cover. Remove tab.

Figure 5-107. Disconnecting or connecting

2. Remove three bolts (B) and flat washers.

3. Remove seven bolts (C) and flat washers.

right camshaft gear housing at cylinder

4. Remove two cap screws (D) and flat washers.

6R rocker arm cover,

Install

1. Install two cap screws (D) and flat washers.

2. Install seven bolts (C) and flat washers.

3. Install three bolts (B) and flat washers.

4. Position transmission oil cooler end shroud retaining

tab on cylinder No. 6R rocker arm cover. Install bolt

(A) securing tab and cover.

Figure 5-108. Removing or installing rocker

arm cover bolts and cap screws.

5-64