Section VII. REPLACEMENT OF VALVE ROCKER ARMS, ROCKER ARMSHAFTS, AND VALVE CLEARANCE ADJUSTING SCREWS

Install

Remove

Remove oil pan sealing thread and clean oil pan mating

Apply a thin coat of gasket cement, Specification MIL-C-

10523 (ORD), on the oil pan flange and install sealing

surfaces thoroughly.

thread.

Removing

installing

oil

pan

sealing

thread.

S e c t i o n VIl. REPLACEMENT OF VALVE ROCKER ARMS,

ROCKER

ARMSHAFTS,

AND

VALVE

CLEARANCE

ADJUSTING SCREWS

4-14. General

structions

removal

installation

and

procedures. Figure references are listed under

This section contains instructions for the

appropriate headings in the table. Instructions

replacement of valve rocker arms, rocker arm

a p p l y to either left or right side of the engine.

shafts and valve clearance adjusting screws.

Refer

for

illustrations

and

in-

Table 4-6. Valve Rocker Arms, Rocker Arm Shafts and Valve Clearance

Adjusting Screws

4-62