Figure 4-124. Removing or installing engine oilpan.

Remove

Support

oil

pan

adequately

before

removing

1. Cut locking wire and remove 12 drilled head bolts (A)

remaining two nuts and washers then remove oil

and flat washers attaching the oil pan to crankshaft

pan.

damper and oil filter housing.

Install

2. Remove 27 of the 28 self-locking nuts (B) and flat

1 . Install 28 self-locking nuts

(B) and flat washers

washers attaching oil pan to each side of the crankcase

securing oil pan to each aide of

the crankcase assembly.

assembly.

2. Install 12 drilled head bolts

(A) and flat washers

Note. One nut and washer are left installed on

securing oil pan to crankshaft

damper and oil filter

each

side

the

oil

pan,

near

the

center,

housing.

prevent oil pan from falling and being damaged.

Figure 4-124. Removing or installing engine oilpan.

4-61