 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
6 . REMOVE AND DISCARD BEARING (3).
NOTE
a. Place housing (4) on two wood
Bearing on same side of cast depression is
blocks with cast depression (2)
normally loose and must be removed first.
up. Do not place blocks in way of
bearing (3).
5. REMOVE AND DISCARD BEARING (1)
ON SAME SIDE AS CAST
b. Using drive punch and hammer,
DEPRESSION (2).
remove and discard bearing (3).
7. CHECK STRAIGHT SHAFT (5).
a. Using micrometer caliper set,
measure outside diameter of bearing
surface (6).
b. Replace straight shaft (5) if meas-
urement is less than 2.1637 inches
(54.958 mm).
8. CLEAN CROSS SHAFT ASSEMBLY.
a. Clean straight shaft and piece parts.
See page 2-2.
9. INSPECT CROSS SHAFT ASSEMBLY.
a. Inspect straight shaft and piece
parts. See page 2-5.
4-466
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals