 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
ASSEMBLE
NOTE
Bearings are the same and will fit either side of
housing.
11. INSTALL NEW BEARINGS (3) AND (4).
a. If bearings (3) and (4) were removed,
go to step 1lb. If bearings were not
removed, go to step 12.
b. Using arbor press, press bearing (4)
into housing (5) opposite cast
NOTE
depression (6) until seated against
Spring washers must be installed with cupped
shoulder (7).
face toward spacer.
c. Turn housing (5) over.
10. INSTALL NEW SPRING WASHER (1),
d. Push bearing (3) into housing (5)
RING SPACER (2), AND SECOND NEW
until seated against shoulder (7).
SPRING WASHER (1).
NOTE
Sealant compound will harden In approximately
15 minutes at room temperature. Steps 12
through 18 must be completed before compound
sets up. If compound hardens before parts are
assembled, parts will have to be disassembled
CAUTION
and cleaned and assembly repeated.
Do not install housing with cast depression
12. APPLY SEALANT COMPOUND TO
facing spring washers or equipment damage
INNER RACE (8) OF BEARING (3).
will result.
Apply a light coating of sealant com-
a.
13. INSTALL HOUSING (5).
pound to outer half of inner race (8)
a. Install housing (5) with bearing (3)
of bearing (3). Bearing is on same
and cast depression (6) facing away
side of housing (5) as cast
from spring washer (1).
depression (6).
b. Using wiping rag, wipe off any sealant
b.
Using wiping rag, wipe off excess
compound on straight shaft (9).
sealant compound.
GO TO NEXT PAGE
4-467
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals