 |
|||
|
|
|||
|
Page Title:
DISASSEMBLE CROSS SHAFT ASSEMBLY |
|
||
| ||||||||||
|
|
 TM 9-2520-270-34
2. DISASSEMBLE CROSS SHAFT
ASSEMBLY (1).
a. Remove key washer (2).
b. Using mechanical puller kit, remove
bearing unit housing (3).
c. Remove spring washer (4), ring
spacer (5), and second spring
washer (4).
d. Discard two spring washers (4).
4. CHECK BEARINGS (6) AND (7).
a. Using telescoping gage set and micro-
3. INSPECT BALL BEARINGS (6) AND (7).
meter caliper set, measure inside
a. Inspect bearings (6) and (7) for
diameter of bearings (6) and (7).
damage. See TM 9-214.
b. If either measurement is greater than
b. If bearings (6) and (7) are not
2.1659 inches (55.014 mm), go to
damaged, go to step 4.
step 5.
c. If either bearing (6) or (7) is
c. If measurement is 2.1659 inches
damaged, go to step 5.
(55.014 mm), or less, go to step 7.
GO TO NEXT PAGE
4-465
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals