 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2520-270-34
36. CHECK GEAR (1).
37. REMOVE OIL LUBE BLOCK (3) AND
a.
Using telescoping gage set and
GASKET (4).
micrometer caliper set, measure
a. Remove two screws (5) and
inside diameter (2).
washers (6).
b.
Replace gear (1) if measurement is
b. Remove lube block (3).
greater than 5.9051 inches
(150.000 mm).
c. Remove and discard gasket (4).
39. REPAIRER AND HELPER
TURN HOUSING (9) OVER.
40. INSPECT FOUR BRAKE PADS (10).
38. INSPECT LUBE BLOCK (3).
a.
Inspect four pads (10) for damage.
a. Inspect lube block bores (7)
See page 2-5.
and (8) for chips and dirt.
b.
If pads (10) are not damaged, go to
b. If bores (7) or (8) are plugged,
step 41. If any pad is damaged, go
clean them. See page 2-2.
to step 42.
4-244
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals