Install two clutch anchor pins

Note position of top of clutch pack relative to

transmission housing when seated. Install two bolts

4910-572-8701 (8356186) (A) to lock clutch pack

in compressed position. Tighten bolts to 10 to o12

Install reverse-, intermediate-, and low-range clutch

pound-feet torque. Remove compressor assembly

pack (A) into housing (B) with slots (C) toward

4910-572-8643 (8356187) (B).

bottom of housing.

NOTE

When properly installed, front (upper)

surface (D) of intermediate clutch reaction

plate should aline with rear surfaces of

power takeoff openings.

Install two clutch anchor pins (A). Flats on pins

must seat in slots in clutch pack.

Install two spacers (A). Using lifting eye 4910-673-

3801 (10865773), (B) install turbine shaft (C) and

high-range clutch assembly (D) as rebuilt in