 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 NOTE
In step 25 (fig. 5-108), measurements for
selection of proper diaphragm gaskets are
Install diaphragm (A) over guide bolts (B). Tap
being made. Figure 5-107 illustrates points
diaphragm until it seats against spacers. Install six
at which measurements are made. The
5/16-18 x 1-inch bolts and washers (C), evenly
diaphragm, when install, must compress
spaced. Tighten all six bolts to 10 pound-inches
the entire clutch pack. The selection of
torque. Using a thickness gage, measure clearance
proper g a s k e t s d e p e n d s u p o n t h e
between diaphragm (A) and housing (E) and (F)
measurements taken in step 25 (fig. 5-
and opposite side as shown. See figure 5-107.
108). To determine gasket pack to be
Record both dimensions. Retighten two bolts 4910-
installed in step 28 (fig. 5-111), average the
572-8701 (8356186) (D), and remove nine bolts
two measurements obtained in step 25 (fig.
and washers (C). The average of the two dimen-
5-108). Then choose gaskets as follows:
sions will be the required gasket thickness. (Guide
(1) If average measurement is 0.010 to
bolts are part of set 4910-572-8710 (8356165).)
0 . 0 1 5 - u s e one 6774406 (73342) (0.012 thk)
gasket
(2) If average measurement is 0.016 to
0.021--use one 6774407 (73342) (0.016 thk)
gasket
(3) If average measurement is 0.022 to
0.027--use one 6774408 (73342) (0.021 thk)
gasket
(4) If average measurement is 0.028 to
0.033--use one each 6774406 (73342) (0.012 thk)
and 6774407 (73342) (0.016 thk) gasket
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals