Section VII. OVERHAUL (REBUILD) OF INTERMEDIATE-RANGE CLUTCH PISTON HOUSING AND LOW- AND REVERSE-RANGE CLUTCH PISTON HOUSING ASSEMBLIES

figure 5-74. Refer to paragraph 6-3 and table 6-3

5-24. Cleaning

for wear limits information.

Refer to paragraph 5-2 for cleaning recom-

mendations.

5-26. Assembly

(fig. 5-74)

5-25. Inspection and Repair

a. If any anchor pins (18) are being replaced,

Refer to paragraph 5-3 for general inspection and

press them into flat side of plate (16) until ends of

repair recommendations. Repair and overhaul

pins project 0.880 inch from flat side.

(rebuild) points of measurement for fits, clearances,

b. Install ten springs (19) in plate, and make

and wear limits are indicated by small letters in

certain they are properly seated in holes.

Section VII. OVERHAUL (REBUILD) OF INTERMEDIATE-RANGE

CLUTCH PISTON HOUSING AND LOW- AND REVERSE-

RANGE CLUTCH PISTON HOUSING ASSEMBLIES

(6) If either of two anchor pins (53) need

5-27. Description

replacing, pull pins from housing (52).

Refer to paragraphs 2-3 through 2-5 for description

(7) If any of six anchor pins (54) need

of the intermediate-range clutch piston housing and

replacing, press pins from housing (52).

clutch piston housing

low-and reverse-range

assemblies.

5-28. Disassembly

(fig. 5-74)

LEGEND

to,

fig.

5-75.

NOTE

All related items not covered in a and b

below or in separate rebuild sections, were

removed from the transmission as outlined

in paragraph 5-6, steps 40 through 45 (fig.

further

5-45). No

5-40 through

disassembly of those parts is required.

a. Intermediate-Range Clutch Piston Housing

Assembly (fig. 5-74).

(1) Remove 12 springs (34) from housing

assembly (25) only if replacement is necessary.

(2) Tap housing assembly to loosen piston

assembly (22), and remove piston assembly.

(3) Remove outer seal ring (20) and expander

(21) from outer groove of piston.

WARNING

Do not dispose of Teflon seals by burning;

toxic gases are produced.

(4) Remove inner seal ring (24) and expander

(23) from inner groove of piston.

b. Low- and Reverse-Range Clutch Piston

Housing Assemblies (fig. 5-74).

(1) Tap housing assembly (fig. 5-76) lightly to

loosen low-range clutch piston assembly, and

remove piston assembly.

(2) Remove reverse-range clutch piston (47) in

the same manner.

(3) Remove outer seal ring (49) and expander

(48) from low-range clutch piston.

(4) Remove outer seal ring (1, fig. 5-75) and

expander (2, fig. 5-75) from reverse-range clutch

piston (3, fig. 5-75).

(5) Remove low-range clutch piston hook-type

seal ring (50) and reverse-range clutch piston hook-

type seal ring (55) from housing (52).

5-32