Section IX. FSG 38, CONSTRUCTION, MINING, EXCAVATING, AND HIGHWAY MAINTENANCE EQUIPMENT

TM 746-10

5-56. Oxygen-nitrogen Related Equipment

b. Coat exterior, unpainted, ferrous metal surfaces

of items with P-10, wrap with greaseproof barrier

Clean and dry manifold chargings, pump assemblies,

material, and secure in place with tape.

refrigeration

exchangers,

precoolers,

vaporizer

c. Cushion items with cellulosic cushioning

assemblies, and heat exchangers per paragraph 3-3 and

material and individually pack in weather-resistant

as specified in MIL-C-52211. Preserve and pack items

fiberboard boxes. Close and seal box with tape (fig 5-

per provisions contained in paragraph 4-28 for oxygen-

1). Mark per paragraph 3-5.

nitrogen related equipment.

5-58. Panel Assemblies

5-57. Pump Assembly, Oil

a. Cushion dial glasses and control knobs with

a. Coat interior surfaces with operating fluid and

cellulosic cushioning material and secure in place with

allow to drain.

tape.

b. Seal opening into items that permit direct entry

of water with tape or a combination of tape and

greaseproof barrier material.

Section IX. FSG 38, CONSTRUCTION, MINING, EXCAVATING, AND

HIGHWAY MAINTENANCE EQUIPMENT

clutch assemblies with P-10. Wrap preserved areas

5-59. Cylinder Assemblies

with greaseproof barrier material and secure in place

with tape.

Preserve and pack cylinder assemblies per paragraph 5-

11f

b. Cushion items with cellulosic cushioning,

individually pack in weather-resistant fiberboard boxes,

5-60. Valves and Mechanical Assemblies

close and seal with tape (fig 5-1), and mark per

paragraph 3-5.

Preserve and pack four-way valves, valve assemblies,

sprocket drive assemblies, traction drives, winch

5-64. Oil Pump, Hydraulic

assemblies, drive assemblies, and housing assemblies

per paragraphs 5-18 and 5-19.

a. Coat interior surfaces with operating fluid and

allow to drain.

5-61. Paving Breakers, Air Motors, and Control Valve

b. Coat exterior, unpainted, ferrous metal surfaces

Assemblies

of the item with P-10, wrap with greaseproof barrier

material, and secure in place with tape.

Preserve and pack items per paragraph 4-2.

c. Cushion items with cellulosic cushioning,

individually pack in weather-resistant fiberboard boxes,

5-62. Miscellaneous Construction Equipment

close and seal with tape (fig 5-1), and mark per

paragraph 3-5.

Preserve and pack pneumatic drills, roll crushers, push

beam assemblies, A-frames, blade assemblies,

5-65. Outrigger Crane

fairleaders, rotary tillers, drill-rig assemblies, strikeoff

assemblies, reducers, and drive and rotor assemblies

Coat unprotected metal surfaces with P-1.

per provisions contained in section II of chapter 4 for

construction equipment.

5-66. Pressure-reducing Stations

5-63. Mechanical Assemblies and Components (70

Pounds or Less)

a. Coat exterior unprotected metal surfaces with P-

b. Seal openings with tape or a combination of

a. Coat exposed, machined surfaces of lubricator

tape and greaseproof barrier material.

assemblies, chuck assemblies, chest valve drifters,

backheads, crank assemblies, and motor and

5-67. Heater, Concrete Mixer

Preserve and pack items per provisions contained in

section II of chapter 4 for construction equipment.

5-10